|
Page 4 of 4
ASSEMBLING OSYMETRIC plates on 110 mm compact standard with Campagnolo or compact Stronlight geometry (star shiffed by 180° in theclockwise direction)
| B1 front |
B1 back |
|
|
1. Insert the 5 circlips (washers) in to the 4 screws and lugs as shown picture B2 front
10mm diameter circlips, 1 mm thick
2. 2 - Position the small 38 teeth plate as shown in photo B3 front (on this standard, the top dead centre of the plate is marked R38, and is posioned at the bottom in relation to the crank, and not behind the crank at the top, as for the Shimano, FSA, etc international standard).
| B3 front
|
B3 back |
|
|
3. Position the large plate as shown in photo B4 front and B4 back (the mark R52 is at the bottom in relation to the crank). Insert screws. Tigthen.
| B4 front |
B3 back |
|
|
4.View of crank at top dead centre (see B4 front above) and at bottom dead centre (see B5 front below).
5. Adjusting the front derailleur
In certain cases, because dimensions are not standard, it is sometimes necessary to file off about 2mm at the end of the 5th arm. For this, see photo 8. This is the arm opposite the Shimano standard crank, the one behind the standard Campagnolo crank. This is done so that the chain can rest on the bottom of the plate groove and not on the edge of the 5th star.
<< Start < Prev 1 2 3 4 Next > End >>
|
